FalkxFPV FW10 GPS + QMC5883L Compass (18 mm)
$23.99
- Upgraded 10th Generation Chip: Adopting the new 10th generation chip, with high sensitivity, low power consumption, miniaturization
- Built-in QMC5883L Compass: Course is stable without deviation, providing precise support for landing and automatic flight
- More Position Modes: Support GPS, Galileo, BDS, GLONASS, IRNSS five-mode positioning, fast positioning in any area
- Signal Stable: Carefully modulated ceramic antenna, it can achieve precise positioning, even in complex environments such as cities and forests
- Small and Lightweight: 18mm x18mm size, only 7.9g weight, this gps module is easy to mount on any RC airplane or FPV fixed-wing aircraft, making setup a breeze
Specifications
| Receiver | u-blox 10th generation, 120 channels |
|---|---|
| Constellations | GPS, GLONASS, BeiDou, Galileo and IRNSS |
| Compass | QMC5883L, on the same board |
| Antenna | Ceramic patch, tuned to hold a fix among buildings and trees |
| Size | 18 × 18 × 7.6 mm — the small square type, and smaller than the M100 Pro's 21.2 mm |
| Weight | 7.9 g |
| Mounting | On a five-inch and under it goes on a bracket at the back tilted 45°, where it sees sky and clears the props. Seven inches and up it lies flat on the top plate toward the rear |
| Not for | The Pixhawk. That autopilot wants its own GPS on its own port — this is for the Betaflight-class boards |
| Against the M100 Pro | The same receiver and the same compass for less money in a smaller board. The M100 Pro publishes its update rate, its baud rate and its temperature range, and comes with the lead and heat-shrink; this one publishes none of those |
| Not published | FalkxFPV give no input-voltage or baud figure. This class of module runs on the flight controller's 5 V rail — check yours before wiring it |
| Manufacturer | FalkxFPV |
You might also like
Reviews
No reviews yet — be the first.
Sign in to leave a review.